Research Using Biometrics Ltd Sensors and Instrumentation in Japan

Daisuke MORIOKA, Ichiro KITAYAMA, Tsutomu NISHIGAKI, Masato KITANO, Takashi YAMANAKA, Yosuke IKEHARA, Hideyo KOYAMA, Takashi MORIMOTO, Hideki SONOBE, Noriyuki MIYAZAK

A Biometrics Ltd electrogoniometers was used as part of a mechanical measurement system for gait analysis.

Hiroshi Goda, Tatsuo Hatta, Kishigami Hirotoshi, Tamotsu Ikeda, Satomi Yamada, Yoshihiko Shibukawa

Biometrics Ltd EMG sensors were used to record the suprahyoid muscle group, which is used to elevate the pharynx during swallowing.

Yuya Matsumoto , Masatoshi Seki, Yasutaka Nakashima, Takeshi Ando, Yo Kobayashi, Hiroshi Iijima, Masanori Nagaoka, Masakatsu G. Fujie; Robomech (Robotics and Mechatronics)Journal (2017) 4:15

Biometrics Ltd DataLOG portable EMG Data Acquisition Ssytem was used to collect muscle activity during an elbow flexion movement.

Nishida K, Hagio S, Kibushi B, Moritani T, Kouzaki M. 2017

Bilateral measurement of 12 muscles were taken using 24 Biometrics Ltd SX230 EMG sensors to compare the difference in muscle activity between FFS (fore-foot strike) and RFS (rear-foot strike) runners.

Md. T. l. Khan, T. Kurita. Biomedical Science and Engineering, 2015, Vo. 3, No. 1, 9-14

This study aims to determine if there is a significant difference in muscle activity between younger and older subjects and therefore if age is a contributing factor to knee joint functionality. Biometrics EMG sensors are used to record muscle activity of subjects and this data is presented, compared and discussed.

A. Saito, H. Akima. PLoS ONE October 21, 2015

Biometrics Ltd Goniometers are fundamental in this study to ensure that a determined angle was reached and maintained throughout data collection. Data from other measured parameters is collected, compared and discussed; the Goniometers were used to control the knee joint angle to ensure a reliable and repeatable evaluation.

Hiroaki Yano, Naoki Tanaka, Kiyotaka Kamibayashi, Hideyuki Saitou, Hiroo Iwata. The Scientific World Journal Volume 2015, Article iD: 849831.

Biometrics Ltd Goniometers are used to support this investigation into commercially releasing a new gait rehabilitation device developed for Stroke patients. Subjects are instructed to walk using the gait rehabilitation device and a 'real' sloped surface, Ankle Goniometer data is recorded to confirm that the new device allows for healthy motion.

Risa Iwasaki, Ginga Yokoyama, Satoshi Kawabata, Tomotaka Suzuki. Journal of Physical Therapy Science. 2014 Jan; 26(1): 57-61

This study aims to analyse the physical characteristics of subjects carrying out a lifting activity in order to contribute to information regarding the mechanism and development of low back pain. Two Biometrics Ltd Goniometers were applied at specific points along the backbone of each subject for the duration of the experiment. The effects of lifting with and without load are discussed and verified using Goniometer and muscle activity data.

Yoshiyuki Hirakawa, Michiya Hara, Akira Fujiwara, Hirofumi Hanada, Shu Morioka. Pain Research and Management. 2014 Sep-Oct; 19(5): 251-256

The subject population was evaluated at determined time intervals post TKA surgery. Biometrics Ltd Goniometers were used to measure hip ROM during active movement. Goniometer data is presented alongside other measured parameters to determine how significantly neglect-like symptoms contributed to pain.

Giuseppe Lisi, Tomoyuki Noda, Jun Morimoto. Frontiers in Systems Neuroscience 2014; 8: 85

Finger angle was measured using a Biometrics Ltd Goniometer throughout the duration of this finger-tapping study. Subjects were instructed to tap their finger (right hand side or left hand side) while a lower limb assistive robot perturbed the leg. Observations from the initial comparison are discussed to determine the effect on finger tapping when the leg is perturbed.

Matsuura R, Arimitsu T, Yunoki T, Kimura T, Yamanaka R, Yano T. Biology of Sport, Volume 32, No.1 2015

Biometrics Ltd EMG sensors were placed over the Vastus Lateralis muscle of each subject performing cycling sprints, raw EMG data is converted into RMS data for inclusion in a statistical analysis along with other measured parameters. Cycling sprints were performed under temperature controlled environments in order to identify the relationship between environmental temperature and neuromuscular efficiency.

Nobuyoshi Hashimoto. Bulletin. Hiroshima Institute of Technology. Research Vol.49 (2015) 83-87

This study aims to determine the requirements of a welding simulator in order to reduce the risks involved with training inexperienced individuals. Subjects, including welding professionals and beginners, are instructed to perform several welding-based tasks while a Biometrics Ltd Goniometer, attached to the wrist, and Biometrics Ltd EMG sensors recorded valuable movement data. The data collected is presented along with the outcome of the welding tasks to confirm the significant differences between the two subject groups.

S Kasahara, J Ebata, M Takahashi; Journal of Physical Therapy Science 2007; 19:251-256

The purpose of this study was to evaluate the repeated one-leg heel-rise test method of ankle plantar flexion in MMT with kinematic measuring devices and EMG. Biometrics Ltd electrogoniometers were used to monitor ankle and knee movements during the test.

R Matsuura, H Ogata, T Yunoki, T Arimitsu, T Kimura, T Yano; Journal of Physiological Anthropology 2007, 26:51-57

Biometrics Ltd SX230 EMG sensors were used to collect lower extremity muscle activity during each of ten cycling sprints.

Y Toshihiko, T Kumiko, I Hidemi, K Mikiko, F Kimie, T Katsuyuki, M Katsumi; Journal of Human Nursing Studies 2006, vol 3, pg 11-21

Biometrics Ltd SX230 EMG sensors were used to measure to muscle function.

R Matsuura, H Ogata, T Yunoki, T Arimitsu, T Yano; Journal of Physiological Anthropology 2006, 25:267-273

Biometrics Ltd SX230 EMG sensors were used to collect lower extremity muscle activity in repeated cycling sprints.

T Wakahara, J Ushiyama, H Kanehisa, Y Kawakami, T Fukunaga; International Journal of Sport and Health Science 2005, vol 3, 75-82

Biometrics Ltd electrogoniometers were used to measure the angles of ankle (SG110A) and knee (SG150) joints in this study of lower extremity biomechanics.

N Kawashima, D Nozaki, MO Abe, M Akai, K Nakazawa; Journal of Neurophysiology 2005, 93:777-785

Biometrics Ltd electrogoniometers were used in this study using a passive locomotion device in spinal cord injury patients.

H Ojima, S Miyake, M Kumashiro, H Togami, S Meng, K Suzuki; Clinical Biomechanics 1991; 6: no 4; 221-229

This paper shows the reliability and validity of Biometrics Ltd biaxial electrogoniometric analysis in the quantification of wrist circumduction. The reliability tests demonstrated sufficient accuracy of the device. Also, validity of the measurement was recognized because the tests simulating wrist circumduction and cineradiography revealed that it could accurately detect the angle between the long axis of the forearm and the third metacarpal bone.